The T-Model simplifies the Osterburg grid of 8,591 cells into a 23,136 mini-cell grid structure based on the measurement of the average size ridge unit.  Each Osterburg 1mm x 1mm cell was divided into five mini-cells each with an area of approximately .45mm x .45mm.  The Osterburg cell distributions, frequency of occurrence and quantitative weights were then re-defined whereby combinative ridge formation types are redistributed and placed back into original form within a “mini cell” framework (Table 2).

 Table 2

Adjusted quantitative weights for ridge unit types, including pores, creases, scars, cores and deltas, found in 23,136 .45mm x .45mm "cells" based on frequency of occurrence.

Given that the average fingerprint impression contains relatively equal amounts of ridge and furrow detail, the Osterburg “empty cell”, which represents approximately a 2mm length of continuous ridge detail, was restructured to contain five .45mm x .45mm mini cells each bearing half unrecorded furrow detail and half continuous ridge detail.  The  frequency of occurrence results for individual and compound ridge formation types found in Osterburg’s cell structure were redistributed based on the number of specific ridge unit types found in each mini-cell.

For example, an Osterburg 1mm x 1mm cell containing a single “spur” is restructured as five ridge unit types in five mini-cells as follows:  1 ending ridge unit, 1 bifurcating ridge unit, 1.5 continuous ridge units and 1.5 furrow units.  As a result of this redistribution, approximately 19,711 furrow units were found to exist in the total grid of 42,955 mini-cells.   Since ridge and furrow units share a common border (which means ridge and furrow edge contours equal) and since furrow width is impacted by ridge edge contour, the furrow unit is omitted from the T-Model.  The total number of mini cells used to define cell distribution and frequency of occurrence changes from 42,955 to 23,136.  As a result, new cell distributions with new frequency of occurrences based on individual and independent ridge unit types were then defined. 

NEXT PAGE >>> 

Quantitative Weight for Ridge Unit Types

Quantitative weight for ridge unit type is defined as a positive number based on the inverse or reciprocal of its frequency of occurrence.  Quantitative weights for the most frequently occurring individual ridge formation events were defined based on frequency of occurrence in the 23,136 mini-cell framework.  Although based on empirical data, the continuous ridge, ending ridge, bifurcation and dot are the most frequent ridge unit types used by latent fingerprint examiners to effect identifications, for purposes of a more complete model the frequency of occurrence for other, more rare types, were included, i.e. cores, scars, creases and pores.

Note:  Quantitative weight for ridge unit types must also consider the frequency of ridge unit position or intervening ridge count to its nearest neighbor (see Intervening Ridge Count).  The product of these frequencies define a ridge units total weight (absent qualitative reduction factors).